New Life Games LLC
Arcade Games, Pinball, Crane Games, Redemption Games and Other Stuff => Arcade Games **Video** => Topic started by: RONR11 on August 15, 2017, 04:43:38 PM
-
I got a unico zero point optic shooting game, my question is calibrates on screen but not during the game. I have the flash but not the impact so I'm not clearing any targets. When calibrating the guns I see the X and Y increase or decrease when shooting . Anybody know if the X and Y setting should be low or high numbers thanks Ron
-
Where is the dot on the screen when you pull the trigger?
Have you cleaned the monitor yet and checked the guns? It's common for the lenses to fall out, be ripped out, or be otherwise damaged. Also check the optical sensor on the PC board inside the gun to make sure it didn't fall off or break off. That's another common failure. You really need a good gun to determine if it's a board issue or a gun issue.
-
Thanks for info Channel, the manual has no info how to calibrate .Im using a happ gun I got from eBay and it is off about 1in on screen so I'll take apart and check your suggestions. One problem I have now is when I turn game off it won't save the settings? Any thoughts on putting in a battery on the 5 volt line? Thanks Ron