New Life Games LLC

Bill Validators, Currency Acceptors and Printers => Other Bill Validators => Topic started by: foster on June 10, 2019, 01:13:40 AM

Title: UBA-10 in IGT S2000
Post by: foster on June 10, 2019, 01:13:40 AM

In 2014 I acquired UBA-10 for S2000, someone helped me With newer firmware
It worked great after update


I had to put the machine in storage for almost five years


Now it cycles like it clearing a jam in the validator happens every 1-2 minutes


I do not remember what I did after the update to get it working


Any help will be appreciated

Title: Re: UBA-10 in IGT S2000
Post by: rickhunter on June 10, 2019, 08:01:12 AM

Did you try reflashing to see if that fixes it?  Check gears on cash can make sure they spin and are no "jammed".

Title: Re: UBA-10 in IGT S2000
Post by: foster on June 10, 2019, 10:40:29 AM

I did refresh with the firmware someone sent me, from 2014

Cash can works in WBA-12

Left side gears spin as tries to clear the jam

So I can power it I have a temp harness made that uses the 12V from the AC Distribution unit
Which has a 12V & 5V Switch Mode Power Supply in it
also handy for powering my Arduino based TITO (5V)

Title: Re: UBA-10 in IGT S2000
Post by: rickhunter on June 10, 2019, 11:16:57 AM

So when you power it only with power and no signal cabling, does it still do the behavior every 2 minutes or so?  It's like the thing is rebooting?  Maybe your main power supply is erratic?  Do you have another one to try?

Title: Re: UBA-10 in IGT S2000
Post by: foster on June 10, 2019, 02:24:53 PM

It does the same thing whether its connected fully to the machine supply or standalone (only power)

WBA-12 cycles and works fully when connected to machine, which I installed right away due to issue with the UBA

It is an issue with the UBA-10
I only have one UBA-10 and a couple of WBA-12
I checked voltages, first rule of troubleshooting all within spec.

Title: Re: UBA-10 in IGT S2000
Post by: rickhunter on June 10, 2019, 02:38:24 PM

There's probably an issue with your transport then, since the cash can works on a WBA.  Maybe you can have the transport tested by someone who has a known working system.

Title: Re: UBA-10 in IGT S2000
Post by: foster on June 10, 2019, 03:13:12 PM

The UBA  the head and transport are single unit, unlike the dbv and wba.

Chassis has couple gears and levers to interface UBA to cash can

I’m going to decode error flashing on led
I just remembered it flashes the error code

Title: Re: UBA-10 in IGT S2000
Post by: foster on June 10, 2019, 08:53:50 PM

I am thinking it has major issues beyond my expertise

Any sensor test I get red flashing LED
Quick reference guide does not explain enough about the led modes for sensor test