I removed the printer harness from the RS232 PSA-66-ST printer.
Then I plugged the 14-Pin BB2 printer harness directly into the printer interface board on the back of the printer.
Turned on the power and it powered up fine...the motor pulled in and lined up a new stack of tickets perfectly.
In the settings, I set it to "PSA-66-T" but won't complete communication and comes up with a "Printer Com Error".
I shut down and changed printer jumper ....still no go...changed to "Netplex" in settings...nope...nada.
I think I have the wrong firmware for this goddamn POS.
Have to go to FuturelLogic website and search for the firmware
I need, make a cable for comm to work and upload it to the printer.
Turned on the power with "Feed" button depressed on printer gave me this sheet of printer configuration below.
You can see I circled questionable firmware and baud rate config.
Click on photo below to enlarge if needed...>>>