New to me PE with issues

[Badbaud]

Bingo! and it looks like the main power header has already been updated.

[phurst]

Ok, back at it. I now have a new backplane and I scooped up a superboard as well. Got everything installed, now when I power on, I get "Call Attendant" with both candle lights flashing. Reset key does nothing.


If I open the door, I get "Door Open" "Call Attendant", and "EEPROM Data".

.

I can press the little white button, screen blinks, close the door, then turning the reset key takes me to a stats page.


I can browse and reset stats, but that'sit. If I hit Bet One, it verifies data, then goes back to plain old "Call Attendant".

Thanks for the help thus far, progress has been made (I think...).

[Badbaud]

Press the white test button WITH THE DOOR OPEN until you hear a DING.
Then release the white button and close the door.
If you get another error turn the jackpot reset key and the game will come up.

[knagl]

Just to clarify Badbaud's post, when you have the door open and the EEPROM DATA error, press and hold the white Self Test button inside the machine for at least five seconds. If your speaker is working you should hear a ding. Next, close and latch the door, then turn the jackpot reset key switch once and release.

Repeat the procedure if needed if a different error message appears.

[phurst]

That's what I'm doing. I'm not getting a ding, but I'm not concerned about audio at this point. Hold it in for 5+ seconds, screen blinks when I let go, close the door, turn reset key and I get the stats page. Exit the stats screen and then it just says "Call Attendant". No other errors, and machine won't react any further.

[Badbaud]

You may have some bad door optics.

[phurst]

Installed new door optics today, and no change in behavior. I'm showing just under 10v on the cabinet side, and just under 6v on the door side. I'm not sure what else to check to verify they're functioning.

[Badbaud]

The door side should be pulsing, can you hold your phone camera up to it and see the pulses?

[phurst]

I see no pulses through the phone camera unless they're incredibly subtle and I just can't make them out. Since I'm getting voltage at the optics connector, I assume my "new" optics are suspect? They're not terribly expensive if trying another set might yield different results.

[phurst]

Ok, I'm a dummy. I was looking at the cabinet optic, not the door one. I can see that it's emitting light, but it seems to be solid on, I don't see any flashing.