New Life Games LLC

General NLG Chat => General Chat, Slot Shop **Tech Talk** Welcome wagon and other stuff. (Off-Topic Post Welcome) => Topic started by: Rjdavison77 on August 12, 2019, 11:20:29 AM

Title: Installing PHX-1 Printer to Cherrymaster harness
Post by: Rjdavison77 on August 12, 2019, 11:20:29 AM

Instructions for installation are not real clear.
Besides power and ground, where do the 5 other wires go? I was told the yellow wire went to pin 23 on solder side.

Title: Re: Installing PHX-1 Printer to Cherrymaster harness
Post by: Stayouttadabunker on August 12, 2019, 10:45:55 PM

You have the Pyramid pulse printer - not the POG printer.
I'm hoping you have 4 dip switches on the side of the printer.
If so, dip#4 should be "down" to be in the "On" position to act as a POG printer.
Normally Dips#2 & Dip#4 are "ON"

Here's a link to the manual for the PHX printers...>>>

https://na.suzohapp.com/images/pdf/Phoenix-Printer-Booklet-RevB.pdf

You need the wiring schematics of this "pulse" printer to know how to hook it up to your Cherrymaster.
Do you have the pinout diagram for your CM version?
Below is a photo of the printer label with the dip options.
Click on photo to enlarge...>>>