New Life Games LLC
**Video Poker, Keno, Slots, 21** Gaming machines => WMS Williams Video => Topic started by: Eddiie on November 25, 2019, 12:08:21 PM
-
Anyone know what pins power this board?
-
Should be the ones on the top left next to the SPN "ethernet" plugs. They should be connected to one another. I will verify with my mech bb1 tonight when I get home.
-
Should be the ones on the top left next to the SPN "ethernet" plugs. They should be connected to one another. I will verify with my mech bb1 tonight when I get home.
Is it Pin 3 +12v and pin 7 GND?
-
8 pin molex connector
1 - +24v
2 - +24v
3 - NC
4 - +5V
5-8 Gnd
-
8 pin molex connector
1 - +24v
2 - +24v
3 - NC
4 - +5V
5-8 Gnd
Thanks!
Definitely do not have pin 3 connected to 12v.
-
What is this board used for?
-
This board drives the LED's on the door that light up the reels in all the different colors. The main power from the cabinet has a pigtail that splits the power into the board and a harness that powers the fluorescent bulb on top the reel glass. Here's a photo wired up in cabinet.
Yellow square is power from cabinet after the pigtail that power the flourescent bulb
Red square ends up in the 5 pin cable that powers the Digit LEDS on the door plus some lights.
The bigger molex harness is the cable that goes to the multi-colored leds on the top of the reel windows.
One of the SPN cables comes from the hub that is under the reels and the other cable goes to the door.
Door Photo
Red Square power coming from the SPN Lamp Matrix board. Red is +5 volts the two black leads are grounds.
The leftmost grey spn cable connects to the animator board on the button panel.
the Middle grey spn cable connects to the SPN Lamp Matrix
The yellow one connects to the panel right next to it.
-
Great! Thanks. If any of these are not connected is there a tilt?
The SPN input comes from the other cable plugged into the SPN matrix board?
How about power for the coins/in lines played board?
-
The power for the lines played board is supplied by the SPN cable. There are three power sources for these door units:
1. The 5 pin plug (detailed above 5v) that powers the actual lights behind the glass.
2. The SPN cable has power to drive the lines played leds and led digits.
3. The 24v power that comes from the pigtail just before it connects to the spn lamp matrix board. It powers the fluorescent bulb on the door.
-
Rick, you are the man!