New Life Games LLC
**Video Poker, Keno, Slots, 21** Gaming machines => WMS Williams Video => Topic started by: brokenticker on March 19, 2021, 08:10:35 PM
-
I have a BB2 startrek with a 26" top monitor that went bad, found a replacement but power input is different ,need pinout for this 8 pin connector thanks
-
Anybody, it’s a tatung lcd
-
E. See if you can get the model number off of that Tatung LCD and I'll look up some schematics for ya.
You might have to make an adapter plug.
-
If you remove the 2 screws and pull the plug out, you can look at the wire colors. WMS uses the same wiring color for their power.
-
Thanks bunk
-
I did open up rick and the wires were mostly black and gray, I think its from a bally , has touch screen but not needed for this, thanks
-
I'm not getting any hits on the numbers in that 1st photo with L26LA50W2W53A02.
and I can't make out anything on the 2nd picture E.
This monitor I found on ebay is a Model # LA26XX....does it look like yours?
Here's the link to it...>>>
https://www.ebay.com/itm/Tatung-L26XX-26-LCD-MONITOR-For-Parts-Repair-/193435795758 (https://www.ebay.com/itm/Tatung-L26XX-26-LCD-MONITOR-For-Parts-Repair-/193435795758)
On this particular monitor, the sticker says DC+5/12/24v volts up to 2.5Amp draw...is yours similar?
I gotta run out the door ....won't be able to get back to this until later E.
Good luck!
Click on photo to enlarge if needed...>>>
-
Yes same monitor, thanks
-
Sticker on cabinets
-
Wait, is it from a Bally or a WMS? You post the stickers that say WMS. If it is a 26 from a bally it is most likely from a cinevision machine. These are the pinout for the "standard" alpha cabinet power to monitors
pin 1 +5, pin 2 +12, pin 3 +24
pins 5-7 are ground.
Pins 4 and 8 are not used for the monitors.