New Life Games LLC
**Reel Slots** Gaming Machines => IGT S and S-plus Reel Games => Topic started by: starcrest on September 01, 2014, 04:05:35 PM
-
Some people have never seen one Except In a casino and others may have worked on one,
I got one and lost all reports of what It Is....(1989) haven't seen one since...
I thought we could share with others on what It Is, and what to do with It...let everyone have exposure to this Slot...
If you guys that have worked on It, will you give me your Input....To jog my memory...
Right now I have no MPU /CPU only Mother board....I tried to Install a IGT S+ MPU board on it , But; The support can
(which has the transformer screwed on the mpu board and can) was 1/4 inch too tall and will not fit under the Switch control box
(power on /off and reset sw)....Therefore I don't know what parts to order....
Can you help us all............Hope I'm not out of place......and pray my pics come out ok.....Hope everyone had a happy Labor day....
...Roy... :EmoticonHelp4: :EmoticonHelp4:
-
here Is more Pics.....
-
1989 is going to be a "S" slot or a very early S-plus. The slant tops take a different MPU tray then the uprights. Pictures are too small and fuzzy to tell
-
It would be an S+ since it has a DBV in upper cabinet.
-
I'll see If I can take better pics......
-
Try these pics
-
The serial # is ...463791--- Model # is ...Gc36CI --- Date MFG. ...1/96
-
It is a S-plus slant top
-
Coorslight you are right about the MPU tray....I tried the S+ and It wouldn't fit, By a 1/4 of an Inch.....Once I figure out what It Is I can try and order the right MPU and Tray.....
Roy
-
you can see the difference here. I have the tray but no MPU. You can have the tray for just shipping cost if you need it.
-
If I am not mistaken....This is what I'm looking for, any suggestions
MPU Board P/N: 75505704 Rev B 2496 GTC ...Or MPU Board: 75505704 Rev B 1096 GTC 10mhzfor a Haywire...model # Gc36CI....serial # 463791.....Date MFG.....1/96
-
Get the tray from coorslight115 and then just buy any S+ 10mhz mpu board and you are set. You should get spare S+ mpu boards anyway while you can still get them.
-
I agree Rick, Coors light, Can you measure that tray for me... from top to bottom on each side.....Width (10 7/16" and Length (13 5/8")It should be a little shorter on the width.....by 1/4 "......or so....
It seems like the one I already have for S+.....If It fits, let me know how you want work out the details.....I'm Open.....
Roy
-
Slant top S+ trays are different than upright S+ trays form my understanding
-
Slant top S+ trays are different than upright S+ trays form my understanding
We stated that in #3 post... :wave: :wave:
-
Yes It Is quite different, Coorslight will be checking with me to see if we got a match....
Roy
-
here are measurements
-
Hey man, I think that Is It from the looks of It.......How do you want handle the details?
You want to PM or Mail me....I would like to give you compensation and pay for shipping...
I'm In the process of ordering a Mpu board, Maybe they will tie in together...Thanks... :applause: :applause:
Roy