New Life Games LLC
Bill Validators, Currency Acceptors and Printers => Printers - ALL => Topic started by: jakah440 on October 31, 2022, 02:49:11 PM
-
Working on getting a TITO setup working on my MK7. I have been successful in getting it to accept tickets thanks to Justin Kalis's instructions but the printer is not printing. It shows up in the machine identification but i thing it has the wrong firmware. It is showing 3RUSAAW01. what i can find online is for Aristocrat in a Gen3 Futurelogic is that it should be 3RUSAA703.
Anybody know if that is correct and if so could i flash the firmware? What's needed? or is there someone that can do this?
Thanks in advance for the help.
Justin
-
Anybody help on this one?
Thanks, Justin
-
If you can go in to your machine and print a demo ticket you are good with the firmware.
If it shows up in the machine odds are its communicating and is compatible.
If you can print a demo ticket you need to start looking toward your payout settings (im not familiar with MK7 machines)
The TITO doesnt care what type of firmware you have, the machine does and by a demo ticket that proves everything you need.
-
Thank you. Yeah it will not print a ticket from the machine. I did get it to print a ticket out by pushing a button on the printer. It shows a firmware from what I found to se for an ainsworths machine.
-
Here is the printout from the printer i have.
Shows firmware from an Ainsworth.
Looks like i need 3RUSAA703.
Anybody able to re-flash this for me?
thanks, Justin
Manufacturer Name ID Number Printer
AGS GRUSA4100 Gen 2
AGS GURUSA211 Gen 2 Universal
AINSWORTH GAMING TEC GRUSA5009 Gen 2
AINSWORTH GAMING TEC GURUSAAW6 Gen 2 Universal
AINSWORTH GAMING TEC 3RUSAAW01 Gen 3
ARISTOCRAT(MK6) GRUMK6004 Gen 2 Universal
ARISTOCRAT(MK6/MK7) GRUSA5015 Gen 2
ARISTOCRAT(MK7) GUR001AI2 Gen 2 Universal
ARISTOCRAT(MK7) 3RUSAA703 Gen 3
-
I could never get a Gen 3 to work in a MK7 machine.
I always use a Gen2 or gen2 universal.
-
Might be best to put out a WTB for a new printer with the firmware on it.
Thanks for the info!!
Justin
-
Hmmm that baud rate says 9600, whereas the other one's I've seen on this board has been 19200.
?