Candle light keeps blinking - Game King 6.2

[Tilt]

Just bought a GameKing 6.2 

After connecting the candle light it just keeps on blinking all the time.

Any ideas how to stop it from blinking?

Thanks!

Moonman

« Reply #1 on: July 01, 2012, 08:34:32 PM »

Did you try pressing the service button ??

Buzz

« Reply #2 on: July 01, 2012, 09:15:43 PM »

Take out the light bulb.  It's likely looking for the back end casino network, which it isn't connected to.
knagl

« Reply #3 on: July 02, 2012, 12:00:04 AM »

Turn reset key, are there any soft tilts listed?
turniphead

« Reply #4 on: July 02, 2012, 04:52:55 AM »

Put more paper in the printer.

ohiogaming

« Reply #5 on: July 02, 2012, 05:17:27 AM »

I think what KNAGL said is correct.  I looked around after posting this and found an earlier thread talking about this.  I think I'll just let it blink and disconnect it if I get tired of it blinking unless someone has a better solution.  There is paper in the printer and when I turn the key I get the attached message.

Thanks everyone for responding.

Moonman

 
 

[Tilt]

« Reply #6 on: July 02, 2012, 06:22:22 AM »

I think you need to "disable" the drop box.  try looking at options 3.1.2.3

rjpohl

« Reply #7 on: July 02, 2012, 07:30:17 AM »

I'm not sure what you mean by "disabling the drop box"  and not sure how to look at options 3.1.2.3 - too "techie" for me - sorry.
MOONMAN

« Reply #8 on: July 02, 2012, 01:37:13 PM »

I think when you set up your printer u might have chosen the wrong validation.  I always use the standard printer validation.  Try clearing the machine and setting it up again.

madwookie

« Reply #9 on: July 04, 2012, 01:11:33 PM »

 
Quote from: MOONMAN on July 02, 2012, 05:17:27 AMI think what KNAGL said is correct.  I looked around after posting this and found an earlier thread talking about this.  I think I'll just let it blink and disconnect it if I get tired of it blinking unless someone has a better solution.  There is paper in the printer and when I turn the key I get the attached message.

Thanks everyone for responding.

Moonman

 

That error/issue happens on some of the GameKing games as it is looking for a connection to the validation system. I just let it blink... seems like a casino that way with lights flashing!

If you disable the printer that light stops flashing, and whatever you do, DO NOT accidentally set it to anything other than standard validation, or you will regret it!!! Trust me! Some people just remove the candle bulb as has been suggested as well.

CaptainHappy