1
IGT S2000 and Vision Games / Re: S2000 - Install a FutureLogic GEN1 printer
« Last post by Faircloth on Today at 05:33:21 PM »I am planning to install a FutureLogic Gen 1 printer in the top box like the original post has done. My question is about the interface cable he used to go from the printers provided cable (8 pin netplex and three pin power) to the Ten pin netplex and two pin power on the board in the back of the top box. I have looked but find no where that sells this. I can fab it if I knew the pin to pin wiring.