This is my first post. Please be gentle. I am VERY mechanically capable and know EM from reviving an old pinball machine. I have all the tools!
Bally 873a
3 reel
5 payout 25cents
I bought this machine from an old storage building and I need some guidance please
1.) began at the top and found everything in order except a fried b25-925 and some serious cleaning.
I have to order some parts to get the multicoin function working, so I am working on a single coin and have the top(upper) payout
disconnected. (pulled out at the plug)
2.) went thru the reels and they are function fine. [size=78%]I have all the switches(reel) in the correct order and working.
They had everything jerry rigged so I undid their misdoings. It now accepts a coin properly says coin accepted and spins.
3.)So down to the hopper
the hopper was frozen. I took the mechanical section (plate) apart and cleaned it. took the loose and it works freely.
The hopper now can spin freely with just using my fingers.[/size]
I am getting no payout from it... seems electrical? So I want to test the motor first... It looks good, but looks can be deceiving.
Is it 110 to the 2 lugs on it? don't want to just throw 110 on it and fry it...
I have read thru reno's stuff and don't see how to test the whole hopper outside of the machine.
Knowledge and assistance would be greatly appreciated.
Thanx in advance
-=Fred=-
Quick question: There is a key switch on the arm side of the machine that contacts a microswitch. By chance is that a hopper
override to pull all the coins from the hopper?