Pick up from Stafford TX

Asking $3500

Call or text 979-383-4210

Another update.

Changed the Battery in the TSE TSE Box again and it now fully shows the Love Boat Image on the upper LCD. Perfect, that's out of the way.

I still don't have an image on my lower LCD. I tried a second CPU and it's not displaying anything either.

I bypassed the LCD and hooked up a Computer Monitor, still no signal with either of my CPUs. I checked the VGA Cable by using it from the TSE to the Computer Monitor, and it works. Shows the Love Boat image.

So, now I'm guessing I've got 2 bad CPUs, which both were shipped to me as "Tested".

I guess I'll order a 3rd and 4th CPU and send the other 2 back to them for testing/repair.

I'm, so close. Lol.

Curtis ash100

I tried the double diamond MPU....this time with the bill validator and cash can installed and was able to get the reels to spin.  It seems there is a problem with my original MPU.  I will have to reach out to member Lookes to see if repairing my MPU is an option.  Thanks for the advice, this is progress.

If you are sure the cable and reel 5 connector are good, no pins pushed out the back, I'd try yet another MPU.

Greetings all,

I've got a real head scratcher here with a 5 Reel Vision game.

Reel 5 spins backwards on boot up, when it decides to even spin at all. Of course it immediately goes into a Reel Tilt that I can't seem to figure out.

Here's a breakdown of everything I've tried so far.

Originally the game was fubar, so after some deep cleaning and adding the missing parts I was able to get to the point of Please Close Main Door. Which, of course would not clear. So, 3 MPUs later and adjusting the Optics several times and changing them out for known working ones, I finally got it to recognize the Door being closed.

I Cleared and Keyed the machine and it was good for a day. Then it quit again after a few spins the following day and I received Door Open MB and Reels Disconnected.

I changed out the Backplane (960 type) and machine wouldn't even boot with that one. So, I put a different Backplane in and I got right back to the Reels Disconnected Error.

Next, I changed out the Reel Harness with a spare (Backlit Harness in place of the original non-backlit, because that's all I had) and the Reels came back to life and spun normally.

Day 3. I finish up with some cosmetics, Top Glass, Reel Glass, etc. and now the #5 Reel attempts to spin with the Main Door Closed, but doesn't make a complete spin before it tilts. It's not touching anything, I checked that first.

With the Door open, it sometimes spins backwards, other times it doesn't spin at all. So, I installed another Reel Harness, no change. Swapped in a different Reel, no change, swapped Reels 4 and 5, stays with the #5.

At this point, I'm not sure what else to try.

I could try another Backplane if someone thinks that could be the issue. Or does it sound like something with the Software? SG Chips, perhaps? It's using SG173 with Stepper Base 000440. Both of which I assume are correct. I know the SB is anyway. Double Diamond Run 45 Credit 5 Reel.

Does anyone have any additional suggestions on what to do next?

I'm going to go ahead and change the Backplane once more just for grits and shins. I'll let you know if that helps.

Thanks, Curtis ash100