game king 6.2 video not centered

[grimley49]

Noob question.  Can anyone explain how to adjust horozontal\vertical alignment on the video?  It's a flat lcd touchscreen.  It's not where the monitor itself is mounted, the video is not centered in the monitor.  I'm guessing it's like a computer monitor, it's done onscreen somehow ... but I see no buttons, etc., anywhere that I can find.  I do have a key chip if that's how it's done.  Thanks in advance !!!

[TheAirBalancer]

I adjust both of mine with a little set of 5 buttons that come with the LCD. On one machine it is mounted just above the screen. The other is mounted on a magnet and can be located where ever you want within the limit of the length of the wire. Try pulling your monitor out and see if it's the magnetic type and is hidden back behind the screen, mine was when I first got it.

[idylewild1]

Usually this is caused by the video input setting. When you find the setup buttons on the monitor there should be a setting for video input-- 044   --- 3902----  or AVP. This must be set to the correct setting. Hope this helps. Also some monitors have a reset button you can try. 

[grimley49]

Ok thanks guys.  Sounds like I need to look around harder for those setup buttons.

[Buzz]

Usually this is caused by the video input setting. When you find the setup buttons on the monitor there should be a setting for video input-- 044   --- 3902----  or AVP. This must be set to the correct setting. Hope this helps. Also some monitors have a reset button you can try. 

Jeff It doesn't happen very often but it does happen. Changing a set of software on a 3902 board, the picture will come up about a inch or so to my right. All the LCDs I have are Ceronix and I have a remote control to adjust the picture to center.