game maker hopper jumper

[Nepa Coin Op]

i have another GM v7000 here i got with no hopper.... im gonna just set it up coinless.... anyone know what to jump on the hopper plug to eliminate hopper jam errors when its looking for a hopper ??


thanks

[Badbaud]

Here are my solutions.
BALLY HOPPER ELIMINATE

JUMPER 6 & 10 ON HOPPER SIDE


OR:
ON 26 PIN 2X ROW PLUG JUMPER PIN 12 TO 19
RUN WIRE FROM PIN 4 OF 26 PIN PLUG TO
PIN 4 OF THE 8 PIN MOLEX CONNECTOR
KEY WAY IS AT 6

[Nepa Coin Op]

Here are my solutions.
BALLY HOPPER ELIMINATE

JUMPER 6 & 10 ON HOPPER SIDE


OR:
ON 26 PIN 2X ROW PLUG JUMPER PIN 12 TO 19
RUN WIRE FROM PIN 4 OF 26 PIN PLUG TO
PIN 4 OF THE 8 PIN MOLEX CONNECTOR
KEY WAY IS AT 6

still getting a hopper jam error after the jump

[Badbaud]

Error could be backed up in software, try a clear chip and start over.
Select "hopper none".

[Nepa Coin Op]

Mains I have dont give the option to choose hopper on or off but I have it jumped and the error is now gone, booted right up to demo mode n plays fine........only other issue I always have with GM's is after a clear I can never get the 10th game to show up in the menu.... after doing the clear i reset dips, reboot, set max bets, reboot with 10th game chip in it then asks me to cycle key a chip was changed but never adds the new game into the menu.... obviously im doing something wrong in that process

[Badbaud]

Some mains, M0-M1, only allowed 9 games.

[Nepa Coin Op]

That’s what’s in it an M0-M1 set

[Badbaud]

They all have M0-M1-G0-G1 the numbers on the chips vary from bar games to upright games to slant wide screen.
To clear demo mode go to terminal ID and enter 11111111111111111 then hit CR