I'm having an extremely difficult time trying to get the WMS BB2 to "see" these SC6607 bill acceptors.
The BVs power up fine and run the box's mechanism upon booting well and I get a slow single green blink.When the game is completed booting up, I close the door this happens...>>>
The BV's green LED stays on the slow blink and never becomes solid green to accept anything nor get past the "Billval Com Error".
History:
I removed the MEI bill acceptors before numbering any of the units from the machines in the hopes of cleaning/testing them before re-installing.
I didn't know they would have the EasiTrax antenna cards and cashbox rfid tags inside them.
I got all of the bill acceptors to work perfectly in my benchtop tester machine.
Sometimes I had to reboot the machine to get the Green LED go solid green after closing the door sensor....no problem.
So I took the entire known working unit over to a cabinet to try it and I cannot get the machine to communicate with the BV.
I was able to sort out a few working combos of billboxes to their respective BV's, on the bench tester, without use of any MEI EasiTrax equipment.
I basically swapped cashboxes until I got a solid green LED.
My questions are:
Since we know that these units have the EasiTrax enabled, and that the cashboxes have assert numbers assigned to each one, that makes each box "BV specific", does that mean that the cabinet is also specific?
In other words, does the cashbox assert # have to be entered into the machine's config settings as well?
If so, it doesn't make sense because my bench tester doesn't have any assert numbers programmed in it.
Would there be something else I'm missing to get communication between the BVs and the machines?
Thanks for any help you can give me on this. and have a great weekend!