SafeRAMâ„¢ Clear Procedure
For a Complete, Full, or Partial SafeRAMâ„¢ Clear,
turn the machine power OFF. Unlock and remove the MPU
Assembly. Remove the Main EPROMs from U12 and U15
and replace them with the corresponding Clear Chips.
Upon ensuring that the MPU Assembly is firmly seated
into the Backplane Board, turn the machine power ON
while depressing the appropriate buttons.
Complete - Press and hold the PSEUDO COIN and
TEST buttons, then switch power ON. When the message
CH C displays in WIN PAID, release the PSEUDO COIN and
TEST buttons. The CH C message is followed by CL C.
Full - Press and hold the PSEUDO COIN button, then
switch power ON. When the message CH F appears in
WIN PAID, release the PSEUDO COIN button. The CH F
message is followed by CL F.
Partial - Switch power ON. The message CH P
displays in WIN PAID. The CH P message is followed by
CL P.
If an error was detected during SafeRAMâ„¢ Clear
as designated by E C, E F, E P in WIN PAID, repeat the
operation.
Upon a successful SafeRAMâ„¢ Clear, the button and
tower lamps flash. Switch power OFF and replace the
SafeRamâ„¢ Clear EPROMs with the corresponding
Mains. Replace MPU Assembly and switch machine
power ON. The machine will enter a Reel Calibration
procedure whereby the home position is recorded in
SafeRAMâ„¢. For tilt-free operation it is important that the
procedure completes without interruption