Lighted door bezel

[chuck300x11]

I have an s+ project machine. It has a WBA bill acceptor. I have a lighted door bezel that is not big enough to accept the duck bill from the WBA. Were there different sized lighted bezels for different acceptors? 

[buybestslots]

 J think both on a  plus  are different then a s2000. on yours  bet the duck bill is not right one since door bezel is already on door

[chuck300x11]

I had to install the bezel on the door.
Here's a pic of the door and bezel I have.

[buybestslots]

looks like a s2000 door bezel    I don't deal in plus games but I think they are different door is flat on front

[CVslots]

Naw, a S2000 would be rounded off edges....like this...are you sure you have the 2 bottom clips in? Put the clips in first, then hinge it up and put in the screws.

[Ron (r273)]

I have the same set up as you chuck300x11 on my S+. The duck bill is to wide to fit the face plate opening.

On mine the two screws are loose so the door will close. But it looks like you could  grind the back side vertical edges down on the back of the face plate, if you can't find the right kind. Not sure they make one for an S+ and WBA.

[buybestslots]

Naw, a S2000 would be rounded off edges....like this...are you sure you have the 2 bottom clips in? Put the clips in first, then hinge it up and put in the screws.

see both pic's you are right we use I game duck bill's on some s2000 by grinding off edge they work great

[CVslots]

Yep, I wish we could make a UBA bezel work on an WBA! I've got a jillion UBA bezels and running out of WBA bezels!

[chuck300x11]

You are correct Ron. I had no trouble installing the bezel but I couldn't shut the door once it was installed. The duckbill is 3 and 3/8 inches wide and the bezel is only 3 and 1/4 inches wide. Is there another bezel that would be big enough even if it wasn't lighted or if I cut the left and right sides off the bezel where the duckbill enters that might work?

[foster]

The WBA/UBA Duck bills are trimmed on the right end only but its not cut off flush but about 1/16" to 1/8" is left on the right end.

That is not a S+ but a S2000 but the BV Bezels are about the same size just one is flat (S+) and one is curved (S2000)

[Neonkiss]

Chuck,
I was able to confirm the problem. You have a door bezel for the DBV and a WBA duckbill and bill validator. You will need to buy a WBA door bezel for a S+
As noted, a S2000 will not work since it's curved.

[chuck300x11]

I have the bezel installed and the door closes 
Here are pics of where I started

[chuck300x11]

Here are pics after removing the right and left sides on the back of the bezel

[chuck300x11]

Here is the bezel installed in the door with the door closed and locked. No more issue!

[CVslots]

Good job! Glad you got it!!!

[Ron (r273)]

Glad my advise worked for you! Thanks for posting.