Yes, 169 + toward F3 as printed on board
Good you did a full cap kit, they are all likely out of spec.
The Vertical IC 192 can cause a multitude of problems. Only one pin should short to ground. That doesn’t prove it is “good” but if more than one pin shorts to ground it is not good. Since you started with V collapse it is suspect.
295 is an important zener diode, that exact diode is tough to find but any 160v Zener. You can verify it isn’t shorted using the diode checker on a digital VM.
XRC5184 is a common failure, although that b+ seems high. It might be holding the board in shut down.
Verify 268 has no shorts (use diode check)
MPSA64, the little transistor by C5184 (284?) verify no shorts
Check that diode too (283)
Lastly, that 160v zener comes from the flyback, if flyback (CPT1500) is bad then you have some soul searching to do. Very rare part that only occasionally comes available.
These boards are great but can be difficult to troubleshoot once they have multiple failures.
Always use an isolation transformer. The power connector in the cabinet is fine, never connect to a wall outlet directly, even if using the low voltage method.
If you need any of the hard to find components let me know. C5184 is especially rare and common to fail. I have a few.
Lastly, I think KLar has a flat rate repair for 1492s. I don’t mind looking at the board for you but if I have no luck you are out the shipping. I am not a professional.
Chris