11
JCM DBV-45, DBV-145, and DBV-200 Bill Validators / Re: IGT S+ with JCM DBV-200 not working
« Last post by Stayouttadabunker on Today at 05:44:19 AM »ok.... if there's no power going thru the harness to the door bezel, that tells us the validator isn't ready to accept bills.
History, did you ever see this bill head work?
The seller didn't mention anything about it not working?
I wish I could help you further other than for you to re-check the connections to the bill acceptor harness.
Make sure no wires are broken on the harness to the pins.
I don't know anything about a dip switch #6 test.
I've never had to check bill acceptors with that.
I just make sure the bill acceptors are flashed correctly, the harnesses are good, the bezel lamps aren't burned out, and the acceptor paths and sensors in the head, are clean.
History, did you ever see this bill head work?
The seller didn't mention anything about it not working?
I wish I could help you further other than for you to re-check the connections to the bill acceptor harness.
Make sure no wires are broken on the harness to the pins.
I don't know anything about a dip switch #6 test.
I've never had to check bill acceptors with that.
I just make sure the bill acceptors are flashed correctly, the harnesses are good, the bezel lamps aren't burned out, and the acceptor paths and sensors in the head, are clean.