Alpha s90000 Handle Issue

[Rpowell18]

i was playing my bally wild rose and using the handle on the side ..I am not sure what happened but the handle is noe stuck in the down position..It still plays but it will not fully retract to the upright position..Is there a release switch to allow it to tract to the full upright position.....thanks

[rickhunter]

 These handle mechanisms are pretty easy to figure out.  Usually a solenoid locks the handle so it can't be pulled down.  When credits are bet, the solenoid releases and unlocks the handle.  At the end of the handle pull, there is a lever that releases the mechanism so it can snap back to the original position.  If this lever is stuck or interfered with, the handle will not pull back to original position.  The issue is that the mechanism is behind the bill validator so it is difficult to get a good look.  You may need to remove the validator cage and printer in order to get a good look at where it is stuck.  If you have one of those endoscopic cameras, it may help.

[Rpowell18]

I will look for it thanks

[Rpowell18]

I found the problem..there is a lever that is loose and I has dropped down on the gears I was able to reach in there and move it an the handle moved back and it works fine.. thanks again