Hi, All:

I have an email from Phil saying the hopper might be findable but the payout wheel not so much.  I see some Bally hoppers on ebay, but no idea if they would work.  I'm game to post a classified here.  Hopefully I can figure out how to do it.  Can anyone advise me what I am advertising for?  This is my first slot machine and I'm pretty much clueless.

Thanks!

Mike

Yes, replying to my own post... lol

After looking closer at the relays, it appears that there are only two types and they are not interchangeable. Therefore I don't believe they can be installed incorrectly. Next step is bench-testing them all for proper functionality. (Apologies for not investigating a bit more before the previous post)

I do however have another question for the group; The handle on this can be pulled at any time. I.E. power off, no coin-in, etc. (see pic) Based upon my experience with other slots, I think there should be a mechanical lock-out system for the handle. I can't imagine a machine was designed so that the handle could be pulled at any time? Or perhaps the mechanism was removed by the previous owner to allow "free" play?

Any thoughts?

Thanks! Lance

Just slide it out forward to get to the mounting screws. (or to see what's back there)

Need help with a Gen2 Netplex. I can't figure out how to remove the printer to check the connectors. I don't see any screws or how the base is attached to the bottom plate. Any help?

The printer is receiving power, will feed paper, but on my G20 when I go to setup/Print vouchers/ is set to YES. It will tilt and not see the printer. So I turn off "Print vouchers" and the printer is therefore turned off and I can continue playing. The BV will read tickets printed from my other GK TITO but I can't verify whether this printer has the proper cables attached as I can't remove it.

I see an empty USB A but not sure whether that is suppose to be attached or where/what board it goes to. Any ideas? If I press feed, it will feed a ticket properly.

Quote from: David Walz on Yesterday at 01:11:05 PM

I really need to locate the push button bulbs for this machine. 

The wedge lamps might be easy to find...the sockets, on the other hand, not so easy to find.
Did you see any imprinted numbers on the glass of the lamps?

I have an abundance of sockets, no bulbs.
Nope, I have been on this rodeo before, just putting some feelers out.