Could be, that's getting pretty technical, the rings usually have paint on them so you can see if they have moved. Is it possible the yoke shifted??
Here is an excerpt from a TPG manual, it's basically answering why block patterns are used to indicate circuit health, it would be interesting to connect a TPG to your monitor, I have worked on boards that exhibit what's referred to as a tombstone effect (not quite square). Since I am borrowing their text, I will also include a link to their device at the very bottom:
The CHECKER pattern displays alternating black and white/red/green/blue boxes as in a
checker board.
This pattern is useful in checking the high voltage regulation of CRT power supply circuits.
Poor regulation results in trapezoidal looking pattern. For CRT type monitors with
insufficient power supply regulation can result in the corners of each box do not touch each
other as they should. This effect can sometimes be reduced by lowering the brightness or
contrast settings.
This pattern is also useful for checking ringing of the video signal as the signal transitions
from black to white. The abrupt, maximum change in CRT video drive current produced by
this pattern should not cause the voltage supplied to the video drive circuit to change in
display device with good voltage regulation. For display device with power supply that does
not have good regulation, softening or ringing in the pattern transitions can result. https://www.arcade-museum.com/manuals-test-equipment/MT830A_User_Manual.pdfhttps://www.ebay.com/itm/323882801012?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=Q5eZpeTKQcq&sssrc=2047675&ssuid=emm0sFORS4-&widget_ver=artemis&media=COPYJust know, this device covers CGA up to VGA but it doesn't appear there is an option to invert colors. As such, RGB will not appear as RGB on Ceronix 1490, 1492, RGB1401 and other monitors that use an inverted color signal.
For inverted monitors I personally use a Craftymech TPG which covers Standard and Medium resolution only.
Chris