Zeus II on BB1...need opinions!

[Yoeddy1]

If you ever plan on using an OLED panel with your BB1, you will need to use the H9.xx version of the game.
The H13.xx version will not work with the BB1+OLED panel.

What are you using for the 5 volts to power the button?

Noted.  Thanks Jim. 

So I have the 4 port RJ-45 hub.  From the motherboard (SPN port), there is an RJ-45 cable running to the "SPN IN" port on the hub.  The power cable (molex cable) is running to the mother board, to a molex plug called Aux Power.

Out of 1 of the 4 ports on the RJ-45 hub, I'm running the other network cable to the RJ-45 port on the SPN board in the belly door.  That RJ-45 cable and the ribbon cable from the HHSR button are the only cables connected to the SPN board.

Thanks,
Jason

[Yoeddy1]

Also, is this WAGE-NET screen typical?

Thanks,
Jason

[Jimise]

Yes, I've seen that on mine when it loads as well.
 

Also, is this WAGE-NET screen typical?

Thanks,
Jason

[Yoeddy1]

Ok, here are the last screens and then I'm gonna shut up for a bit.  Got a 13.x OS and game coming and I'm going to do some comparison.

Here are the screens I mentioned before about the Respin button setup.


You guys see this under Game setup/Zeus options?

Thanks,
Jason

[Yoeddy1]

Perhaps Z2 ran better with the older green MPU.  Faster processor (Pentium 3 7xx MHz) compared to the newer blue MPU with the slower Celeron 6xx MHz processor.

Just a thought.

Jason