tilt code 42 continual

[Mritaliandreamer]

Hey you guys! well been enjoying playing my double diamond deluxe 2 coin quarter machine. today i tried to adjust my coin comparitor with the coin and shut the door and the 2 reel started to spin the  reverse way. i tried to open and close door to clear the error code but still intiltmode. can the clear chip resolve  this issue?

[slots4home]

You may have a bad reel #2
Try this, remove your cmos chip for 10 seconds and replace it and reset the machine
The cmos is next to the reel and game chip.
Be sure not to reverse the cmos chip when you replace it

[Sunrise Side]

Anything rubbing against the reel?

[Mritaliandreamer]

ii thought the pay line glass looked a little to close than normal

[Sunrise Side]

Check to see if the reel is pushed in and seated completely. Make sure the white plastic LED panel mounting studs and nuts are tightened up. This is the coin in , credit display assembly that is mounted behind the reel glass. If the nuts are loose the plastic housing will tilt back and will rub on the reels.

[Mritaliandreamer]

When you say" reset the machine that includes using the clear chip and bv chip?

[cowboygames]

It's an S+, I don't think you can get the harness plugged into the bottom of the reel until it's fully seated. Have you tried swapping the reel with either position 1 or 3 to see if the problem follows the reel or stays with the position?

[Mritaliandreamer]

took the cmos out now getting the 61 61-1 but cant get passed it wondering if i need to use the clear chip as well because the cmos was taken out for 10 seconds.....

[therockinelvis]

No Clear is not needed yet. Since you can't get past 61-1 maybe door optics. When you get 61-1 and close door then turn key, does it go blank then back to 61, or just stay 61-1 with no change? Sometimes when closing the door the optic wires get snagged then broken, or you did not get the latch all the way down.

[Sunrise Side]

If there is a cash can switch and it is not closed you can't get past 61-1