I’m working on a S+.. Owner said it stopped taking coins. I found the screws all loose holding the coin in brackets. Even had one missing. Tightened and replaced the screws. Next I cleaned the coin optics and comparitor. Put it all together and it takes coins, but every once and a while it doesn’t count a coin. It falls into the hopper. I decided to swap out the whole coin comparitor mounting bracket and coin optics, with one I had for a spare, even changed the coin handling wiring harness except the pig tail for the comparitor. After reassembled and played I noticed it still has the same problem. I also noticed that at times when I insert the 2 coins, there is a delay of about 1-2 seconds before they register in the display? I am not sure what to check next? These machines don’t have IO boards, everything done through the. MPU Board. The power supply plug on the mother boards not burnt either.. What am I missing??