Need wiring help with S+ bill bezel light plug conversion from DBV to WBA

[Amechanic]

I’m in the last faze of this DBV to WBA conversion in my S+ Haywire. My last problem is converting the bezel light wires from the DBV plug to the WBA plug. I have everything to finish the wiring. I’m just not sure what 2 wire colors I need to use from my WBA 11 harness? The harness from the S2000 has only a black and white wire. The one I have has 4 colored wires, white, grey, purple, blue. Where do I attach the red/blue, and green/blue wires in the S+ cabinet?

[Amechanic]

Here is what I figured out. The blue/red cabinet wire, goes to the blue wire on the 4 pin plug. Then the blue/green wire goes to the violet wire on the 4 pin plug. I was able to remove the wiring with the connectors from the DBV plug and clip them right into the 4 pin plug. See attached pic.

[therockinelvis]

I never had any problems converting. If I remember right there were three plugs from the wba and 4 plugs from the machine. One plug did not have an end that could be used. Or visa versa. It's been a while.

[Amechanic]

This WBA has only 3 plugs coming from the transport wiring. See pic of transport plug.