WMS BB1 machines not booting

[Stayouttadabunker]

A microswitch button body has two holes on it for a couple of plastic pins to hang onto it.
Below is a couple of microswitches....you'll see the difference where the holes are.
If the plastic pin that's suppose to go into the switches holes are broken, it cannot hold the switch.
You may have to place a WTB ad in the Classifieds section of NLG to get another button or shop around.

Take good photo of the broken button and microswitch you have.
I'm sure someone will have one laying around.
If you have the ones like in the 3d photo below, then see if the microswitch isn't pushed up all the way into the button body like the other ones.
Pictures will tell us a better story.

[newkid3]

Here are pics of the button and micro switch. You can see there is a pin still in the one hole of the micro switch. Both pins on the button are broke off. So I need a button. The micro switch works good so I just need the button.  Can I remove the 20 LINES insert in the button and put it in another one with this kind of button?  I guess I need to place a
WTB ad in the classified section.

                 Thanks

[Stayouttadabunker]

Yeah...The pin broke off of the white part of the button.
The white part does come out of the black plastic body.
It's held in by a tiny raised lip around the edge.
The clear lens pops off, if you push up on the edges.
Those buttons are all over ebay.
I remember I had to get some of those VLT buttons, for a two-row S2000 button deck once.

If nobody has one, give these guys a call...they might have it...>>>

https://www.betsonparts.com/gaming/small-square-white-vlt-push-button.html