Started on a new S2000 project. My first problem a dead machine except the service light. Found the power supply was bad. Next I powered up the machine, but I could not get past close the main door.. Tonight I changed both optics, and the MPU but I still have the same problem that I can't get past the close main door message.. The second MPU, I tried was just bought a couple months back as good working.. It cleared just fine, but the same close main door message stopped me.. I pulled the door IO and swapped with a good working spare, Then I pulled the cabinet IO and found a nut inside with the IO board.. I found that the cabinet IO was damaged (burn mark) from the nut inside.. Swapped it with a good working IO, but no difference??
My Question is do the optics run thru the IO cards? Next is about the optics.. Are the cabinet and door optics the same or different? I would think you have a transmitter, and a receiver? They look the same to me? What am I missing? I was thinking of trying to bypass the optics, but what plug on the mother board do the wires run too? The picture of the optic bypass is very vague. All the plugs seem to be plugged in on the mother board..
Gary