Bally Alpha MEI BVD install/Help needed

[slotdoofus]

I recently purchased 4 Bally Alpha machine. The bill validators had been pulled prior to purchase.

I'm wanting to install MEI validators, (SC6607). I have the harness adapter.

I have no machine to use for comparison. The MEI has the 12 pin connector that I connect the adapter to. On the adapter, I can see what I need to connect to the 5 pi and 2 pin connectors. The adapter has a white 2 pin connector. I can't seem to find a connector in the cabinet that this plugs into.

Also, the MEI has 2 wire bundles, (one has black shielding, the other has white shielding). Each of these "bundles" has 3 wires, (red, white, and black). I see a wire bundle inside the cabinet marked :
CBL-31070-0001 A
JCST 1407

This wire bundle has 4 wires/marked:
Black...MAIN SW COM SDS
White...MAIN SW N.O.
Yellow...MAIN SW N.C. SDS
Orange/yellow stripe...MAIN SW N.O.

Is this where I plug in the red, white and black wires coming from one of the shielded wire bundles on the MEI? If so, which group of wires, the black bundle, or the white bundle?

[pbwizard25]

Tim your inbox is full.. I do not have a machine to look at. I am gonna say the flat 5 and 2 on the adapter need plugged in and the NC and common go to cherry switch for cash can. I believe all else is not needed.

[slotdoofus]

Thanks Scott

[slotdoofus]

I already have 2 wires going to the cash can cherry switch...terminals 2 & 6

I'm guessing the NC and common go to terminals 1 & 5?

[pbwizard25]

You only need 2 wires to the cash can switch. 1 and 3 I assume would be the numbers. Top terminal , skip one and use the next. The wires should come from machine and not dbv harness sorry trying to do this from memory . 

[slotdoofus]

Thanks Scott,

That's the way my machine is currently wired....The red wire to the top terminal, (number 2) and the white/blue to the 3rd terminal from the top, (number 6).

[Ken]

your in box is full