Polygon topper / white LED strip

[Yoeddy1]

Hi guys,

I’m trying to get a functioning polygon topper going, but I’ve had a couple that have bad white LED sections.  These are the LEDs that light the back of the topper insert.  Is there anybody that sells the white LED strips or some other solution to light the back of the topper as a replacement part?  The glitter bar and colored topper ring work great, it’s just that white LED tape strip.

Any help would be appreciated!

Thanks,
Jason

[a69mopar]

If you're not in a hurry,  you can buy 5m/15ft spools of led strips. You can choose 5v, 12v or 24v. I bought from aliexpress. They work great to replace fluorescent lights. I'll post a couple pictures

[a69mopar]

here is a pic of them lighting the glass. There are cut lines, so yoy can cut to length. the tabs at the cut are easy to solder to

[Yoeddy1]

Thanks, Wayne!  So there are solder points then for the existing wiring harness/connector?  Do you know what voltage would be required?  It’s a polygon topper on an IGT G23.

Jason

[a69mopar]

Thanks, Wayne!  So there are solder points then for the existing wiring harness/connector?  Do you know what voltage would be required?  It’s a polygon topper on an IGT G23.

Jason

  You're welcome Jason.   
   I could only guess 24 volts, however you should check the voltage with a meter to be sure.  They come with leads soldered on at the beginning, then after you cut, you can solder onto the end for the next length.

[a69mopar]

Pics

[Jim]

check the wire color, IGT only used two d.c. voltage, solid red wire is 13vdc,  solid orange wire is 25 vdc.

Jim