Getting a saferam error

[startek2]

Hey gang,

We just got this game in.  It was working a few days ago when we ran it.  Today I get a 'saferam corrupted' error.....i pulled the board and found the lithium battery to be totally dead.....i have replaced it.....

What I need to know is 1)what game/version is this?   2) what do I need to do to get the error resolved?  So I need a chip?  If so what chip and where does it go?  This is my first video slot........Pictures are attached....oops the last pic is upside down...that was my not the game lol

[Badbaud]

It's a Bally Game Make. When you replace the battery on a Game Maker you need to run a clear chip in the P10 location with Dip Switch 1 switches 6,7, and 8 on.

You will then be told to remove the clear chip and reset the 3 switches to off.

When you turn the game back on you will be prompted to set up the game options again.

Things like type of door, is it a upright or slant machine, what kind of coin mech, etc. etc.

Somewhere on NLG is a post on what options need to be set.

[CVslots]

This will get you going...if not, you will be real close. Make sure to adjust/change equipment as per your machine (I.e. coin Comparitor, validator, hopper, all the common sense stuff)...


Clear Chip Settings:

Jurisdiction - 5
Primary - SAS
Secondary - None
SAS version - 5.01
Cabinet - Upright
Coin Acceptor - None
Bill Validator - JCM WBA
Printer - Seiko
Hopper - None
Door - Pulsed Optic
Double Down - OFF
Tournament - OFF
EFT - Disabled
Secondary Dev - None
Residual Credit Mode - No Gamble No Attendant Pay
Win Evaluation Preference - Legacy


Program Settings:

Terminal ID - ANY 3 digits (111)
Serial # - ANY 6 Digits (111111)
Host Mode - EFT Disabled
Host Type - Standard
Host Bonus - Disabled
Progressive - Disabled
Validation Type - None
Remote Hand Pay - Disabled
Print Hand Pay - Enabled
Hand pay Exc - Unsecured
Comm Loss Tilt - Disabled
JRCM Control - Operator