Okay, maybe I'll stump someone on this one but hopefully it's an easy fix. A while back, the arm on my Volcano machine got stuck in the down position. I eventually took the whole mechanism apart using the manual as a guide and then put it back together. Somehow, I got the arm working again (turns out it just needed lubrication...hold the jokes). Anyway, I hooked everything back up the way it was and things seemed to be working just fine. Except now, there's a weird new problem.
Only the arm makes the reels spin! Well, all of the rest of the buttons work except for the "Spin Reels" button!
So, I looked inside at the little module (photos attached) that is by the arm. It has three metal tabs and two wires, one green and one yellow. The green one goes to the top tab. And I made a mark to let me know that the yellow one went to the kind of diagonal tab (as opposed to the one on the bottom). When it's hooked up that way, the arm makes the reels spin, but not the "Spin Reels" button. And when I take that yellow cable and plug it into the bottom tab (another photo attached), it makes the "Spin Reels" button work again...but the arm doesn't!! I can't seem to figure out how to make BOTH the arm and Spin Reels button work at the same time- it used to work that way but clearly I hooked something up incorrectly when I put it all back together.
Any insight would be truly appreciated!
~Jim