I decided to dust off my Bally E2000 Progressive slot.
I also need to dust off my brain, it's been 10 years or
so since I've worked on these.
The battery needed to be replaced so I did. This is a
picky machine and if not programmed correctly it will
not run.
I programmed the following values;
2801 = 5000,000.00
2901 = 2,000.00
3001 = 2,000.00
3101 = 4,500.00
(values from a post on the old forum)
If not correct, please advise...
The slot will coin up and I could get a few pulls
then it got intermittent on me. Now when I coin it
up and pull, it tilts with no code.
Before I chase my tail, I'd like to do a RAM clear. These
Progressive units are a different breed and I suspect
maybe some corruption in the memory (5101's) may be
an issue.
I have a zero RAM chip I most likely purchased from
FoxSlots back in the day, but I do not have the instructions.
What boot location (M1,2,3 or P1,2) ?
What should I expect ? (changes in LED / Progressive display)
Todd