Hi All,
So, I've got a DBV-45 attached to a 777, Bally mid-90s machine. I'm not sure if it ever worked, but I'm pretty sure it did when I got it.
I've disassembled everything, checked every plug, but the darn thing just won't 'initialize'.
I've got the DIP switches on the MPU set to DBV = yes. The firmware on the DBV clearly says "bally" written on the EEPROM (Chip?) and on the unit itself. However, it will never "go green" (or red for that matter).
Attached are some photos and some videos.
I've tried with all DIP switches on the DBV-45 set to off, except 8. All off, including 8. Makes no difference. The gears appear to be in proper orientation.
With this unit, there is no rear gear on the cash stacker, it looks like it "winds down" from the top of the unit, and I am able to get that motor to run.
Attached in this file link there are a few videos of what happens during bootup of the machine.
Any next steps folks? Which PINS should I check, on which harness, for correct power/voltage?
https://www.dropbox.com/sh/xh7k6zyei090uia/AAANXiLRa1UBln_i0YnwlAFka?dl=0