My BB2 had the printer removed before I bought it, but the harnesses were possibly left in place. I bought a Gen2 RS232 WMS printer and now it's time for the install. These are the current conditions:
-Harness P1 is plugged into the J5 Printer port on the backplane. The end of that harness is labeled P3 with an empty 7x2 female plug.
-There is a dangling P4 harness with (I guess a jurisdiction doo-hickey) attached A-012938-03-00, and it has an empty 7x2 male plug.
-There is a SPN harness with an empty 4x2 female connector.
I don't see any other disconnected harnesses in the belly.
-The printer has a 7x2 male connector.
-2x2 male connector with black/red/green wires.
-3x male connector with green/green wires.
-A 2x2 male connector is embedded on top of the printer.
The printer dip switches are currently: 1-off, 2-on, 3/4/5/6 are off.
My noobie logic says that I should plug the printer male 7x2 into the P3 female 7x2. Could it be that simple? That still leaves the 2 other connectors and I don't see where they go. I would guess that the 2x2 is power related because of the black/red/green wires, but I don't see any empty ports on the power supply.