I GOT IT!
Okay so FIRST... Thanks You EVERYONE here!
You all are so helpful its awesome
Okay so after a pot and a half of coffee and reading and reading. I went back out to the the shop. I first got in to the machine settings without using the key chip and looked around. Everything seemed set correctly. Keep in mind this is my first S2000 so just getting a feel for the machine, going through the menus etc is all new to me. So I figured it must be like a S+ and if the BV light is on the machine must good to go. Already had the BV manual printed out and ready. During coffee I read about the test mode you mentioned Jim. Proceeded to perform test. Came up with code 2 - Magnetic Pattern Error. Manual says dirty rollers or bad MAG sensor. Rollers freely moved but had a thin dirty/crusty layer on most of them. Could not get it cleaned off. Ended up manually scrapping off each roller with small flat tip screw driver. Blew it out and reinstalled. Now takes every bill I throw at it. Machine is up and running. Played over $100 through it now. Seems okay. Have a few glitches like a bulb here and there but just little stuff. I got the printer connected also. Gotta get paper. Where/who has that? Do I need ink also? PM me if you got paper.
THANK YOU !!!
Robert