1
Bally Alpha Reel Games / Re: bally alpha small screen touch not working
« Last post by armyaviation on Today at 08:56:15 PM »I think they are different but I will check thanks
Welcome to the NewLifeGames.com message forum!
|
1
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by armyaviation on Today at 08:56:15 PM »I think they are different but I will check thanks
2
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by Jolly Rock on Today at 08:50:18 PM »You need to take the cover plate off to see where the cables were connected. At least that is where my problem was (a very loose and poor connection).
3
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by Jolly Rock on Today at 08:46:44 PM »The picture shows where I found my loose usb connection. It is like an extension cable connected with a male and female usb cord that goes to the monitor.
4
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by Jolly Rock on Today at 08:44:35 PM »There is a cover plate over some cables on the back of the door right behind and below the lower touch screen monito.
5
IGT S and S-plus Reel Games / Re: IGT Double diamond S Plus, RESTORATION« Last post by RobinAK on Today at 08:22:47 PM »With SP1271 you can set credit and hopper limits separately, that's the one I use. I like the SP1271 chip also. Here is link for settings using the 1271. http://newlifegames.com/nlg/index.php?topic=514.0[/url NLG Member RB is the man for chips. 6
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by armyaviation on Today at 08:19:05 PM »my screen doesnt use a usb. i understand what you are getting at. does this pic help? are you referring to something somewhere else, thanks
7
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by Jolly Rock on Today at 08:16:22 PM »Re: cover plate on back side of door, it’s held on by ( 2) 5 mm (if I remember right nuts…. NOT screw. Sorry
8
Printers - ALL / Re: Printer head up error on s2000« Last post by armyaviation on Today at 08:14:18 PM »That’s what I was trying to explain above, i swapped the cable and the actual printer in different times, the cable that in there now works with one and not the other
9
Bally Alpha Reel Games / Re: bally alpha small screen touch not working« Last post by Jolly Rock on Today at 08:09:47 PM »Hi, Had a similar problem with my S9000. There is a metal plate protecting the wires on the door behind the lower monitor. The USB cable to this lower touch screen monitor bbehind this plate has a USB male and female connection. Loose connection was helped by slightly bending in the plug to create a much tighter connection. Seems to have cured the problem. The cover plate is held on by 2 screws. Hope this helps.
10
Printers - ALL / Re: Printer head up error on s2000« Last post by Stayouttadabunker on Today at 08:02:34 PM »Swap the ribbon cable to test?
If it works, then you just need a ribbon cable. |
Cell Phone and Pad Mode imode wap wap2 |
NLG Archives Archives @ newlifegames.net Wayback Machine |
Contact Us NLG Shop 928 754-4147 Email Us 1788 Highway 95 30 BHC City AZ 86442 |