igt slant top pe+ double double poker wba 11 no working

[noclue-socal]

jim i will do that right now thanks

[noclue-socal]

hi jim try have no lights

[Jim]

no lights mean no power to unit. make sure power supply is plugged into the wiring harness that goes to the transport unit, its the small two pin connector with black and red wires, or measure voltage there. 13vdc.  see if the white cherry switch has to be pushed in or pulled out to get power to something.no use trying anything else until the red LEDS are lit .


Jim 

[noclue-socal]

jim u may be right
can i use a 12v (no machine power) that is putting out about 14/14.3v as a source to power up bv to see if lights come on

[Jim]

back in reply #15 you checked the voltage going into the power supply, what is coming out??  it should be 13 vdc.  I would not sub a power source, the power supply serves two functions for this unit, 1= provides the 13vdc to operate the unit 2= had the interface comm. board that talks to the cpu.  so if the power supply is bad, you will have to replace it to get the bill acceptor to work. 

try the power supply from your friends machine to see if that will fix your problem.


Jim

[noclue-socal]

thanks every one for all the help (great people on this site)
figure out the transport is bad need new one
can any one  tell me were to get one and should i up grade when i buy one
and do i need the set chip for it

[Jim]

I would upgrade to a WBA-12/13   your preference, one is flash memory, the other is a EPROM memory.   the biggest difference is the four way acceptance, WBA 10/11 only allow one way acceptance.   you will need a new wiring harness for the back of the transport shelf,  the cash can and power supply are the same.  you also have to have it flashed for the proper game IDO.  In your case ID0-022 and IDO-023, that's why switch #1 was flipped down, to use a IDO-023 protocol.  You will need a set chip as well.  never hurts to have one. 


Where are you located?? 

I have everything you would need. 

sent you a pm



Jim

[noclue-socal]

ok you are talking about things i know nothing
will it be easier to send the one i got to get repair
i am in so. california

[noclue-socal]

i want to say thanks to RICHUNTER CVslots  SHAGGY AND JIM and every one else for putting up with me 

by taken every buddy advice and a little luck (no knowledge) i got it working
the wba 11 is bad
by taken the cage out changing plugs and using wba12 from junk machine (pic reply 33) plug in and it started to work it takes bills (with out set chip)
                                                                                 

[rickhunter]

 

Enjoy your poker games.

[noclue-socal]

thank you RICKHUNTER

[CVslots]

And you know, I bowed out of this post when you started checking voltages and whatnot. That's just not the way I go through a machine, but I understand, to each his own. I am THRILLED to see you got this one figured out, and we have likely addicted you, so we will see you more!

Wow, BV was changed and was enabled EVEN without a SEt chip? We've only been saying that for years,  but no one will believe it. Glad you could validate that for me! Some people just do what they do because that's what they've done in the past..others just do what's needed.

Again, awesome job for sticking it out! Jim got ya through the toughest parts (thats why we love him). Pat yourself on the back, have a beer, whatever you do to celebrate! You got it!