Odd behavior after installing tito.

[Retro tech repair]

First off this is the first time i have used a tito so it’s probably something im doing wrong. I built a machine and let it auto play as I always do the machine worked perfectly fine. I install the tito device and now the machine will randomly general reel tilt. I mess with it for a bit check the reel optics check the door optics the bas chip as i had to key the machine again. The tito board is behaving properly other than the machine randomly reel tilting. I try the board in my test chassis and I don’t get any reel tilts in my test chassis. I put my test board in the machine with the tito and again i get no real tilts. The only thing i have changed out side of swapping boards is i put a set of sg363 in the original set came with the machine and is missing there labled.

[Retro tech repair]

It must have been something with that board or software set it seems to be working properly now.

[Stayouttadabunker]

In the same vein, I had an S2000 displaying "SAS Down"and wouldn't accept bills.

I pulled out the processor chip off of the MPU, re-seated it and it works perfectly now.

So I pulled back out the processor chip again and inspect the socket...sure enough, one pin inside the socket was green and oxidized.

Just the simple event of me pulling out the chip and reinserting it gave that pin better contact to eliminate the display error.