Solution to this was...checked continuity in the door optic transmitter wires...good 0 omhs, checked dc voltage at connector- this is the tricky part, with probes in connector I had voltage, plugged optics back in, still would not work. Problem was the connector female connectors on MPU were slightly wallowed out. It would make connector with the pressure of the probes in them, when no pressure was applied, the connection was 5.0 to 6.0 volts. It also passed the "wiggle" test. So I crimped the female connector in on the MPU pass through, now have 5.65 steady volts and door optics now work. Last issue is I have no power to handle release solenoid. I have zero power through connectors all the way to motherboard connector J10. The input test works for the spin button (it should also energize solenoid) but zero voltage . Not sure how to proceed. MPU and Motherboard just serviced by KLAR.