81
Printers - ALL / Need Help with Gen2 Netplex on IGT G20
« Last post by sftechgeek on Yesterday at 02:33:33 PM »Need help with a Gen2 Netplex. I can't figure out how to remove the printer to check the connectors. I don't see any screws or how the base is attached to the bottom plate. Any help?
The printer is receiving power, will feed paper, but on my G20 when I go to setup/Print vouchers/ is set to YES. It will tilt and not see the printer. So I turn off "Print vouchers" and the printer is therefore turned off and I can continue playing. The BV will read tickets printed from my other GK TITO but I can't verify whether this printer has the proper cables attached as I can't remove it.
I see an empty USB A but not sure whether that is suppose to be attached or where/what board it goes to. Any ideas? If I press feed, it will feed a ticket properly.
The printer is receiving power, will feed paper, but on my G20 when I go to setup/Print vouchers/ is set to YES. It will tilt and not see the printer. So I turn off "Print vouchers" and the printer is therefore turned off and I can continue playing. The BV will read tickets printed from my other GK TITO but I can't verify whether this printer has the proper cables attached as I can't remove it.
I see an empty USB A but not sure whether that is suppose to be attached or where/what board it goes to. Any ideas? If I press feed, it will feed a ticket properly.