6 April 2020
I did a search for this subject and maybe I'm not imputing the question properly.
Is there a way to put the GK to "Sleep" while not being used?
I have been turning on the power to the GK whenever I wish to play it and on a few occasions it showed a Call Attendant message and it said the circuit board (Flash) was bad.
This happened again on Saturday.
I turned it off and restarted it and tried to gently push the circuit board drawer back just a bit to make sure it was completely seated.
I tried to turn it off at the switch below the bill validator and then I re-plugged it into the wall outlet.
Eventually it started up again and worked like it should. I've had it "On" for the past three days cause I'm leery about shutting it off again.
Is there a way to put it into a "Sleep" mode like I do with my laptop ? That would keep the circuit board energized but the lights and screen would be dark.
Does turning it on by plugging it in again or leaving it plugged in and using the inside switch cause the board to suffer damage from the sudden electrical imput?
I sure don't want to damage it and a replacement board is a pricey event that I do not want to experience.
Any suggestions?
Wish I could have found this subject on the forum and maybe it's actually there but I simply don't know how to word it to find the subject. If so, Sorry....
Thanks to all.
KeatsPhoenix, Az.