Payouts on 922-R

[rjpohl]

The belly glass was broken and replaced with a generic piece, can anyone tell be what the payouts are?
thanks


also got a few light sockets that work some times, have to rotated the wire on the back of socket.  Any one know of a fix for these?

[Amechanic]

Your machine payouts are listed on the right side of the reel glass and on the top glass. I'm sure the belly glass was just one that said Bally.

[rjpohl]

Damn, my eyesight is worst than I thought.
thanks
Bob

[Amechanic]

Damn, my eyesight is worst than I thought.
thanks
Bob

Hey no problem.. 

[rjpohl]

The quarters are hanging up in the cut out in the knife (see pic).  Any one had this problem and have a easy fix?
thanks

[Jim]

Bob,  something just doesn't look correct in that picture, can't put a finger on it. looks as if the knife is setting out of position for the coin to roll down and out.
also the tips on the pinwheel should be going through that opening that the coin is sitting in??

I think I have a hopper sitting around, I'll check it out this evening.

Jim

[Amechanic]

Jim..
My first thought was that the hopper knife is not the correct one for that hopper, or that the coin pinwheel is for a larger coin.

Gary

[Amechanic]

This is what my extra hopper looks like. To me the it looks like the hoppers knife is farther under the roller. This hopper has a coin guide too keeping the coin from falling back into the coin bowl once counted. Can you get us a better picture of your knife? I do have extras here.

[DavidLee]

Comparing photos, looks to be installed incorrectly or its the wrong part.
Needs to be moved farther away from the pivot roller.

Post additional photos at different angles if possible.

[rjpohl]

Mine does have the guard, I left it off just to show where coin was hanging up.  I'm pretty certain it's mounted correctly.  Here's a few more pics.

[DavidLee]

Better photo angle, everything appears to be right.

Try a piece of tape over the cut out. Just for the heck of it to see what happens.

[Amechanic]

Is the roller on the lever free? I have had them frozen and won't spin.. You might want to try oiling and greasing the hopper motor and gear too. Those style hoppers don't have a brake, they coast just a little when power turns off.

[rjpohl]

I finally left the bottom screw out of the knife, it kept the knife from moving farther toward the center of the hopper.  It is working much better, only one out of ten or so last coins now hanging up.


thanks for all the help guys!

[DavidLee]

The slightest bit of grim will slow a coin.

[rjpohl]

Thanks, I did clean it, I think that was contributing to it problem.