Yeah...I saw
that the Molex for the logic door switch comes outta the J10 harness on the bulkhead board.
Thanks for the jumper pinouts....but I must warn...it's showing pins 1 and 3 being jumped with the blue wire in that Molex photo, NOT pins 4 and 6.
Anyways, I just about had half this J10 harness outta there already!
Found other unused harnesses all stuffed into the left bank swelling up the cheap grey cardboard cover that's rubbing against the logic door...WMS spared no expenses making this machine eh?
Thanks for supplying a good photo.
I checked out the wire colors in your photo coming out of the back of the Molex and they match mine however, the part where the 6-pin Molex comes out of the J10 harness on mine is labeled as [LGC] rather than [P3] which I found strange.
It's obvious to me that [LGC] means "logic".
I'm guessing my harnesses were made in Mexico or somewhere else.
I ended up jumping across pins 1 and 3 and the logic door switch is now bypassed.
These two wires are black w/a gray stripe and black w/a red stripe respectively.