Need 2 Williams 400 Lower Dot matrix Power Supplies

[ucanwin]

I'm in need of 2 working lower power supply units for Williams 400 dot matrix slots.
If possible...... I would like the entire box, one with a 12 pin connector, and the other a 16 pin connector (see picture). I would be open to just 2 working power supply boards if I am not able to get the 2 entire box units.
Thanks,
Jerry

[tollguy316]

I'm pretty sure I can help you out. Contact me after the holiday. Bill

[ucanwin]

Hi Bill,
From what I have been told......my upper power supply board in the lower power supply unit is most likely the cause of my problem. The 5 LEDs on the board inside of the box under the reels are not all lit. #1 and #5 are lit steady. #3 is flashing on and off along with a pop-pop-pop sound. #2 and #4 are off. The other LED way to the left on that board is off. The dot matrix shows Williams. I replaced the bad power supply in the dot matrix unit. Also, I found a blown 10 amp fuse (F-1) in the large board in the lower power supply box and replaced that, with no change to what is noted above.
So, I guess that what I am asking is.......do you by chance have a replacement small board for the lower power supply unit? If so, what would be the cost plus shipping to zip 53132?
Thanks, for any help that you might be able to provide.
Best regards,
Jerry