Is this board correct for my PE+

[chuck300x11]

got my new board today. See pics below that go along with my question. When installing this board I have a connector left over that was plugged into my previous board. This new board is a 1492 H. Is it ok that this is not connected on the board? Don't want to put power to this and ruin something.

[Amechanic]

There are many different versions of the 1492 Ceronix Chassis. That 4 wire plug is from your yoke coil. It will plug into that chassis. If you took out a 1492, then this one should work just fine. Since its setup for IGT, it would work in a Fortune 1 to PE+ as long as that's what it had in it.

The 1492 chassis was used in many early video machines, Bally, CEI, Brunswick, IGT. They are not interchangeable, but with changing of of the jumper setting on the bottom they can be setup for different machines..

[chuck300x11]

Pulled the board back out and found the missing connection. I couldn't see it but I read it on the board. Thanks amechanic for telling me what the connector was. It was printed on the board right where the connector belonged. Game is back together and working 100%