Bally Curve monitor power jumper

[mhorton]

Does anyone have, or have the ability to make for $$ the jumper in yellow on the attached picture? Looks like it has the standard power connector, as well as a two pin for backlight power, and another small two pin for touchscreen power?
I need to get this one running as the wife is getting agitated!
Thanks!

[Trisail]

I can make it. I don't have a Bally to copy. I would need - better picture showing exactly what wires go where and type of connectors or detailed description of how to make it.  I will check my prints to see if I can determine if I have the information later today.
No luck on prints.
Good picture of cable (connector ends (front and back), wires in the connectors to determine which wire(s) goes to which pin and wire lengths) and I should be able to make it.

Tony

[sixcardmark]

Hard to get a good pic.

[Trisail]

If you want a cable that works, gonna need better pictures.  If you want some connectors, wires with pins installed that you can put in the right holes I can try to send that to you. I won't be able to guarantee you get the right parts, but pretty sure. I will check the picture when I get home on a few hours and post back what I think I could do for you. Up to you if you want to proceed after that.
Tony

[Trisail]

So pictures are not enough to get you a working cable. Maybe you can pm me and we can talk.
If anyone else has the needed information maybe they will post.
Tony

[rickhunter]

I've already made the cable for him, I copied the one I had on my monitor.

[mhorton]

I have found the jumper thanks to this community!
Thanks all for your help.
Mike