Main battery low/ options verification required

[Ocitown]

I have an 044 GK and just added a new battery and a GKBDEV39 chipset from a vey helpful member.

After clearing the ram and turning off the non-wap, I had everything working beautifully and I just had to go into the settings and I didn’t think I did too much but I guess I did because now I’m getting a low battery tilt and I just can’t seem to get rid of it and move onto it working.

Any thoughts on this?

Thanks for any and all help.
Scott

[Ocitown]

BTW,The new battery tested well @3.2v.

[RB]

Options verification required is not an error. It always appears after setup. It will go away when you figure out the battery problem.

[Ocitown]

Other than a fresh battery what would be a place to check for this battery problem?

The only thing I have not done is mess with the EEPROM settings.

[sixcardmark]

Did you replace with the correct coin battery with the correct side up?

[Ocitown]

I did,2354 + side up,3.2v checked.

I’m stumped here.

But thank you!

[sixcardmark]

Is machine actually going into a closed door state? Does the MPU have a leaking varta battery on it?

[Ocitown]

This unit does not have that battery,Ron helped me remove one from my spinning machine.

I do not know what a closed door state is?

[Ocitown]

I turn the machine off. I push the white button hold it turn the machine on. It gets me into the clearing of the ram which I do and then go to gameplay it immediately shows call attendant, I open the door and it gives me an alarm for a ram error turn attendant key for more information.
The next screen is a critical data, error, recoverable error, turn attendant key switch to clear which I do and get a blank screen for about five seconds and then press and hold switch for 2 to 3 seconds after I do that initializes the system and makes me wait.

A few seconds later, the main screen appears and then the main battery low options verification required bulletin comes up. All these last steps are done with the door open. I close the door. The only change on this bulletin is call attendant above the main battery low.

I hope this helps and I appreciate the help.

[Ocitown]

I even switched the batteries from my spinning machine to the poker machine again and the spinner machine works with either battery, but the poker machine doesn’t work with either or should I say it’s still giving me the battery message so it’s not the battery

[Ocitown]

I also found a post by Tilt who said cleaning the battery contact points may help,I used 99% but nothing has changed.

[sixcardmark]

If you are getting call attendant then it's seeing the door closed, so that is not the problem.

[Ocitown]

Your correct,the see attendant is only on until I open the door.

[Tilt]

Sounds to me like the problem is most likely on the board itself.  There's a resistor network and comparitor circuitry that tells the MPU when the main battery is low and something in it has failed.  Check with member Lookes, he can probably fix it for you.

[Ocitown]

Thank you so much!

I will look him up tomorrow.