Use Future Logic printer selection for Gen 2's, harness should be the same.
The Printing issue could be dirty rollers on the printer, so the paper slips the the print gets messed up. Clean the rollers and it should fix the printer. OR you don't have the right firmware on the printer.
The key that was used to open/close had the little key/tab removed and someone pulled the key halfway through the cycle. Some dealers do that so you can remove the key when the lock is in the open position, something which is not possible to do when the key has the little tab on it. So if you get a key, take off the tab, then complete the close cycle, you should be able to use the lock with no issues with a regular key after that.
When you run a clear on the machine, it says what the sjur is. Also if you have the machine running, go to accounting and tick on the the version information.
An s9000 cannot use an s6000 hopper.